3M VHB 4952 19mm x 3 meters

The 3M VHB 4952 is ideally suited for many low-energy surfaces, plastics or glass and therefore belongs in every household, as it has very good adhesive properties on many surfaces.

Save yourself the annoying drilling and sticking - it's faster and more flexible!

Specification:

• very high adaptability
• very high adhesion to almost all powder Coatings
• extended design Options
• Reduced post-processing
• quick and easy Connections
• Reduction of production costs

Processing Information:

• Cleaning the Surface
• Wear suitable gloves. Pay attention to the information in the safety data sheet of the respective cleaner.
• Use clean cleaning cloths (lint-free, fragrance-free, plasticizer-free).
• Use suitable cleaning agents (e.g., 3M cleaner for 3M VHB adhesive tapes) depending on the degree of soiling and the surface (no household cleaning agents that moisturize).
• Repeat cleaning until the surface is clean and free of grease. Change the cleaning cloth.
• Use the "3M Silane Glass Primer" on glass surfaces (please note the relevant application instructions).

Applying the tape:

1. The processing temperature (object and ambient temperature) should be between + 15 ° C and + 25 ° C
2. Place the adhesive tape on the surface to be glued, pull it tight, but do not overstretch it. Avoid air inclusions
3. Do not stick the first part of the adhesive tape that was touched (let it protrude and cut it off)
4. Immediately press on / roll on the adhesive tape well with approx. 20 N / cm²
5. Remove the protective cover and attach the second part to be joined
6. Remove the protective cover in one piece to avoid "stop marks"
7. Do not touch the adhesive Surface
8. After removing the protective cover, glue the second part promptly to avoid soiling on the open gluing Surface
9. Pressure on the second part of the sash
10. Pressure on the second part to be joined with approx. 20 N / cm². Avoid air inclusions
11. Important: Make sure that it is positioned correctly, as it is no longer possible to remove it again due to the high adhesive strength
12. Wait for the final bond strength

The final bond strength at 20 ° C is reached after 72 Hours

The process can be accelerated by heat